Hub-Drum With Studs And Races Only, For Dexter 9K – 10K-General Duty Axles, After July 2009, 12-1/4″ x 3-3/8″ (A008-430-05)(BD-123)

Product Description

Fits Dexter 9K & 10K-GD Axle Built – After July 2009

• Axle-Tek Drum 12-1/4″x3-3/8″, 9-123(BD-123 Stamped on Drum)
  • If you are replacing a Dexter drum it will be stamped (9-123).
• 8 on 6.5″ Bolt Pattern
• 8-430-5 Axle-Tek Hub with Races & Studs Pre-Installed (8 – 5/8″-Studs)
• 5,000lb Capacity Per Hub

This redesigned two-piece hub & drum will work as a direct replacement for the one-piece (8-415-2) hub & drums that were used between 7/2009 and 4/2013.
This two-piece design comes standard on Dexter axles made after 04/2013.

Included Parts:
• (1) 382A Inner Race (Already Pressed In) 3.813 OD
• (1) 25520 Outer Race (Already Pressed In) 3.265″ OD
• (1) Hub/Drum – 12-1/4″ x 3-3/8″ Drum Installed
• 5,000lb Capacity Per Hub

Separately Sold Parts: Order these as well for a complete Hub-Drum and Bearing assembly.
9K- 10K-GD Bearing Kit

• (1) 387A Inner Bearing (2.25″ ID)
• (1) 25580 Outer Bearing (1.75″ ID)
• (1) 10-51 Oil Seal (2.875″ x 3.88″)
• (1) 21-88 Oil Cap (Plastic)
  • Upgrade to ST-350-01 Valcrum Oil Cap (Aluminum)
• (1) 46-32 EZ Oil Cap Plug
• (8) 6-109 Coned Wheel Nuts
• (1) 33-52-1 Wheel Retaining Ring

Brand: Axle-Tek
Made In China